General Street Class Rules
1.All vehicles must have current registration and current state inspection.
2.All registration papers and insurance cards must be available at time of tech.
3.Registration card must match vin. number and plate number.
4.No dealer plates are allowed
Ballast
1.Maximum weight 8750
2. No hanging weights are allowed,
3. No hidden weights are permitted.
4. Weight may be in bed.
5. All weights must be securely fastened.
6. No weight allowed in cab and under hood
Chassis and Suspension
1.Must have OEM suspension
2. Must maintain OEM measurements for the body being used. .
3. No suspension modifications
4. All steering must be OEM steering
5. Traction bars are allowed but must be bolt on
Body
1.The body must be an OEM truck body including the full bed floor.
2.No mud flaps or dirt deflector
3. Must have all windows, Must have all working OEM lights, Must have all
interior panels and dashboard.
4. Flatbeds are permitted and must be manufactured.NO HOMEMADE BEDS
5. Factory O.E.M. brush guard and snow plow brackets are permitted
Exhaust
1.Exhaust must clear the rear of the truck.
2.May run mufflers. If no muffler rule number three (3)apply
3. Four(4) 3/8 (Grade 5) bolts in the horizontal portion of exhaust pipe(s) as close to the turbo as possible. Bolts to be installed 90 degrees to each other,
within one inch of each other.
4. Hood stacks are not permitted (Unless legal in the state the truck is licensed by)
5. Aftermarket exhaust and bed stack permitted
6. All vehicles must be equipment to direct exhaust upward
Safety Equipment
1.Dot helmet is highly recommended
2,All vehicles must have a 2 1/2 lb. dry chemical
3.Seatbelts are required to be worn when hooked to the sled
4.Leather shoes, Pants, and Long Sleeve shirt is required
Drive Line
1.OEM rear and front ends required. Must have come factory in a one ton or
smaller vehicle.
2.OEM transmission and transfer case must be used. Must have come factory in a
one ton or smaller vehicle
Tires
1.Tires must be DOT approved no larger than 35x12.50 or 315x75 Metic
Must have factory tire size stamped for verification. If size is removed they will be
considered illegal.
2. No studded tires or tire chains. No alterations to tires permitted. No bar tires.
3. Dual wheels are permitted ONLY if factory equipped. Single rear wheel trucks
are not permitted to run dual rear wheels
4.Dual wheel truck are limited to a tire size of 35x10.50
Brakes
1.Must have four working brakes, Must have working brake lights
Fuel
1.Fuel must be #1 or #2 diesel fuel only
2.No propane or Nitrous
Battery
1.Batteries are not allowed in the cab, unless factory installed. Must be in OEM location
Hitch
1. Must be Reese style hitch. May be reinforcement. Must not extend forward of
the rear axle.
2. Must be rigged in all directions, Hitch mounting point can not be above frame
rails And stationary in all directions
3. No drawbar hitch or trick hitches allowed
4. Hook point must be at the rear most point of the vehicle. and most rearward of
stock location of the tailgate.
5. Maximum hitch height of 26” with a minimum of 3.75”x3” opening.
6. Hitch must be on a level plane with the ground.
Engine
1. Engine must be in OEM locations.
2.No superchargers permitted.
3.No aluminum blocks are permitted unless O.E.M .
4. Fuel injection pump is limited to stock appearing. OEM engine make specific
pump only
5. The use of a RSV (agriculture governor) is prohibited.
6. Aftermarket air filters and air boxes are allowed.
7. Programmers & computer chips permitted.
Turbo
The turbocharger is limited to a stock-appearing, OEM/Factory make-specific charger only. Turbochargers from different years in the same make may be interchanged,
no adapters to accept other model turbo.
1.All vehicles must have current registration and current state inspection.
2.All registration papers and insurance cards must be available at time of tech.
3.Registration card must match vin. number and plate number.
4.No dealer plates are allowed
Ballast
1.Maximum weight 8750
2. No hanging weights are allowed,
3. No hidden weights are permitted.
4. Weight may be in bed.
5. All weights must be securely fastened.
6. No weight allowed in cab and under hood
Chassis and Suspension
1.Must have OEM suspension
2. Must maintain OEM measurements for the body being used. .
3. No suspension modifications
4. All steering must be OEM steering
5. Traction bars are allowed but must be bolt on
Body
1.The body must be an OEM truck body including the full bed floor.
2.No mud flaps or dirt deflector
3. Must have all windows, Must have all working OEM lights, Must have all
interior panels and dashboard.
4. Flatbeds are permitted and must be manufactured.NO HOMEMADE BEDS
5. Factory O.E.M. brush guard and snow plow brackets are permitted
Exhaust
1.Exhaust must clear the rear of the truck.
2.May run mufflers. If no muffler rule number three (3)apply
3. Four(4) 3/8 (Grade 5) bolts in the horizontal portion of exhaust pipe(s) as close to the turbo as possible. Bolts to be installed 90 degrees to each other,
within one inch of each other.
4. Hood stacks are not permitted (Unless legal in the state the truck is licensed by)
5. Aftermarket exhaust and bed stack permitted
6. All vehicles must be equipment to direct exhaust upward
Safety Equipment
1.Dot helmet is highly recommended
2,All vehicles must have a 2 1/2 lb. dry chemical
3.Seatbelts are required to be worn when hooked to the sled
4.Leather shoes, Pants, and Long Sleeve shirt is required
Drive Line
1.OEM rear and front ends required. Must have come factory in a one ton or
smaller vehicle.
2.OEM transmission and transfer case must be used. Must have come factory in a
one ton or smaller vehicle
Tires
1.Tires must be DOT approved no larger than 35x12.50 or 315x75 Metic
Must have factory tire size stamped for verification. If size is removed they will be
considered illegal.
2. No studded tires or tire chains. No alterations to tires permitted. No bar tires.
3. Dual wheels are permitted ONLY if factory equipped. Single rear wheel trucks
are not permitted to run dual rear wheels
4.Dual wheel truck are limited to a tire size of 35x10.50
Brakes
1.Must have four working brakes, Must have working brake lights
Fuel
1.Fuel must be #1 or #2 diesel fuel only
2.No propane or Nitrous
Battery
1.Batteries are not allowed in the cab, unless factory installed. Must be in OEM location
Hitch
1. Must be Reese style hitch. May be reinforcement. Must not extend forward of
the rear axle.
2. Must be rigged in all directions, Hitch mounting point can not be above frame
rails And stationary in all directions
3. No drawbar hitch or trick hitches allowed
4. Hook point must be at the rear most point of the vehicle. and most rearward of
stock location of the tailgate.
5. Maximum hitch height of 26” with a minimum of 3.75”x3” opening.
6. Hitch must be on a level plane with the ground.
Engine
1. Engine must be in OEM locations.
2.No superchargers permitted.
3.No aluminum blocks are permitted unless O.E.M .
4. Fuel injection pump is limited to stock appearing. OEM engine make specific
pump only
5. The use of a RSV (agriculture governor) is prohibited.
6. Aftermarket air filters and air boxes are allowed.
7. Programmers & computer chips permitted.
Turbo
The turbocharger is limited to a stock-appearing, OEM/Factory make-specific charger only. Turbochargers from different years in the same make may be interchanged,
no adapters to accept other model turbo.